Product ID:WALLHIDE INTERIOR S/G MIDTONE BASE, 27-160
MSDS Date:01/16/1990
FSC:8010
NIIN:00N025485
MSDS Number: BMQYT

PPG INDUSTRIES INC (WAS PTTTSBURGH PLATE GLASS CO)

260 KAPPA DRIVE
PITTSBURGH, PA 15238
US

Emergency Phone: 304-843-1300

Info Phone: 412-963-5822

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

ALUMINUM SILICATE

CAS: 1335-30-4

Fraction By Weight: 2-5%

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 10-15%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

1); (CALCIUM CARBONATE)

CAS: 471-34-1

RTECS: FF9335000

Fraction By Weight: 15-20%

OSHA PEL 15 MG/M3 (TDUST)

ACGIH TLV: 10 MG/M3 (TDUST)

HYDROTREATED HEAVY NAPHTHA

CAS: 64742-48-9

Fraction By Weight: 30-35%

FILM FORMERS, RESINS, AND ADDITIVES

Fraction By Weight: 25-30%

INCREASED RISK OF CANCER FROM EXPOS. POTENTIAL

RTECS: 9999999ZZ

IS VERY LIMITED. SINCE OVEREXPOS ARE NOT EXPECTED,

RTECS: 9999999ZZ

HAVE MATL SAFETY DATA SHEET INFO AVAILABLE.

RTECS: 9999999ZZ

SKIN/EYE IRRITATION OR BREATHING DIFFICULTIES.

RTECS: 9999999ZZ

AVOID FREE FALL OF LIQUIDS IN EXCESS OF A FEW

RTECS: 9999999ZZ

LIMITS, THE LEL BELOW THE STATED LIMIT, AND TO REMOVE

RTECS: 9999999ZZ

COATED WITH THIS PRODUCT.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGEST:HARMFUL/FATAL. EYE:CAUSES EYE
IRRIT. SKIN:MAY CAUSE MODERATE IRRIT. INHAL:VAP & SPRAY MIST MAY BE
HARMFUL. CHRONIC:AVOID LONG TERM & RPTD CONT. THIS PROD CONTAINS
TITANIUM DIOXIDE. ANIMALS INHA LING MASSIVE QUANTITIES OF TITANIUM
DIOXIDE DUST IN A LONG-TERM STUDY DEVELOPED LUNG TUMORS. STUDIES
WITH (SUPP DATA)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:REDNESS, ITCHING, BURNING SENSATION AND VISUAL
DISTURBANCES MAY INDICATE EXCESSIVE EYE CONTACT. DRYNESS, ITCHING,
CRACKING, BURNING, REDNESS, AND SWELLING ARE CONDITIONS ASSOCIATED
WITH EXCESSIVE SKIN CONTACT.

First Aid:INGEST:DO NOT INDUCE VOMIT. EYE:FLUSH IMMED W/PLENTY OF WATER
FOR AT LEAST 15 MIN. SKIN:REMOVE PROMPTLY BY WIPING, FOLLOWED BY
WATERLESS HAND CLEANER & SOAP & WATER. INHAL:IF AFTD BY INHAL OF
VAP/SPRA Y MIST, REMOVE TO FRESH AIR. APPLY ARTFRESP & OTHER
SUPPORTIVE MEASURES AS REQD. OTHER:IF ANY OF THE FOLLOWING OCCUR
DURING/FOLLOWING USE OF PROD, CONT POIS CTL CTR, EMER ROOM/MD
IMMED; (ING 8)

Flash Point Method:PMCC
Flash Point:120F,49C
Lower Limits:0.7
Extinguishing Media:USE NFPA CLASS B EXTING (CO*2/DRY CHEM/UNIVERSAL AQ
FILM FORMING FOAM) DESIGNED TO EXTING NFPA CLASS II (SUPP DATA)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. WATER SPRAY MAY BE INEFTIVE. WATER SPRAY MAY BE USED TO COOL CLSD
CNTNRS TO PVNT PRESS (SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, ELEC EQUIP, SPKS & OPEN FLAMES. CLSD CNTNRS MAY EXPLODE WHEN
EXPOS TO EXTREME HEAT. DO NOT APPLY ON HOT (SUPP DATA)

Spill Release Procedures:PROVIDE MAXIMUM VENT. ONLY PERSONNEL EQUIPPED
W/PROPER RESP & SKIN & EYE PROT SHOULD BE PERMITTED IN AREA. REMOVE
ALL SOURCES OF IGNIT. TAKE UP SPILLED MATL W/SAWDUST, VERMICULITE,
OR OTHER ABSORBENT MATL & PLACE INTO CNTNRS FOR DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QUANTITIES IN BUILDINGS DESIGNED AND PROTECTED FOR STORAGE OF NFPA
CLASS II COMBUSTIBLE LIQUIDS.
Other Precautions:IF THIS MATL IS PART OF A MULTIPLE COMPONENT COATING
SYS, READ MATL SAFETY DATA SHEET(S) FOR OTHER COMPOMENT(S) BEFORE
BLENDING AS THE RESULTING MIXTURE MAY HAVE HAZARDS OF ALL ITS
PARTS. CNTNRS SHOUL D BE GROUNDED WHEN POURING. (ING 10)

Respiratory Protection:WHERE VENTILATION IS INADEQUATE, USE A SUITABLE
NIOSH/MSHA APPROVED RESPIRATOR.
Ventilation:PROVIDE GEN DILUTION/LOC EXHAUST VENT IN VOL & PATTERN TO
KEEP CONC OF INGS BELOW LOWEST SUGGESTED EXPOS (ING 11)
Protective Gloves:NITRILE/NEOPRENE RUB/POLYVINYL ALCOHOL.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:PROTECTIVE CLOTHING, INCLUDING IMPERMEABLE
APRON.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
EXTING MEDIA:COMBUST LIQ FIRES. FIRE FIGHT PROC:BUILD-UP & POSS
AUTOIGNIT/EXPLOS WHEN EXPOS TO EXTREME HEAT. EXPLO HAZ:SURFS. TOX
GASES MAY FORM WHEN PROD IS CONTACTED BY FLAME/HOT SURFS. HAZ
DECOMP P ROD:PRODUCE FUMES INCLUDING: CO. HLTH HAZ:HUMANS INVOLVED
IN MANUFACTURE OF THIS PIGMENT INDICATE NO (ING 6)

HCC:F4
Boiling Pt:B.P. Text:>212F,100C
Vapor Pres:0.6
Vapor Density:HVR/AIR
Spec Gravity:1.16
Evaporation Rate & Reference:12 (BUOAC=100)
Solubility in Water:0
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISITC OF THE
SOLVENTS.
Percent Volatiles by Volume:54.30

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE HAZ DECOMP PRODS WHEN
HEATED. WELDING/BRAZING/FLAME-CUTTING ON SURFS COATED W/THIS PROD
MAY (SUPP DATA)

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF I/A/W
FEDERAL, STATE, PROVINCIAL, AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WASTE MANAGEMEN T FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.